CANON
BCI-3e, BCI-6
Black & Color Cartridges
1. Cover the outlet hole with the orange outlet
seal that came with the cartridge (a rubber band will hold this in place)
to prevent ink loss during refilling or with your finger over
the outlet port while wearing latex gloves
.
2. Use the "L tool" provided to
push the Sealing Ball into the cartridge (tap on the 'L tool' if
the ball is stuck). If you can't see the ball just above the "push" then peel back the top label on the reservoir side of the
cartridge to expose the Sealing Ball. This is the ball Canon used to plug up
the hole after they refilled the cartridge.
3. Attach the needle to the syringe and fill with the correct color ink.
4. Slowly inject approximately 13 ml. of Black Ink or 6 ml of Color Ink slowly into the
filling hole until the chamber is almost full. Unused ink may be returned to the bottle.
5. Seal the hole using the
Green Plug. Put your finger on the green plug and twist
until it is seated well in the hole.
6. Remove the orange outlet
seal (or your
finger) from the outlet hole.
7. Replace the cartridge and run 1 - 3 cleaning cycles as per printer instructions.
8. If you have trouble getting your cartridge to print and the sponge side of the cartridge looks dry then drill a hole (or burn a hole with a hot paper clip) into the top of the sponge side of the cartridge. Stick the syringe needle into the sponge and fill with ink. You do not need to seal this hole.
Or print the following pages:
www.my10s.com/black.htm
for Black
www.my10s.com/color.htm for
Color 
If you are filling cartridges to use
later, leave the orange
outlet seal rubber banded onto the cartridge. This will prevent your
sponge from drying out.
Note: Immediately refill any empty cartridges.